Modules
TA-200W+
Super Replacement for the Kenwood TA-200W, KR-9600
This module is listed for individual sale.
Amazing low noise and distortion. Ready to use module replaces the Kenwood TA-200W used in the KR-9600. Repairable, discrete design. Carefully designed to fit the same mounting holes, no drilling or grinding necessary. Includes mounting hardware and 2 KTA1024 driver transistors to replace the old 2SA912 driver transistors.
NOTE: The TA100W and TA-100WA are very similar, but do not run at the right temperature if swapped.
Built with superior output transistors:
| High current: | 15 amp x 2 pair |
| High voltage: | 160 volt Vce |
| High dissipation: | 160 watt |
| High current gain: | 8,000-20,000 |
| High heat transfer: | Theta 1.5 vs 1.8 |
These same power transistors are used in the 140 watt per channel Marantz SR8012 and the Yamaha RX-A2070.
| Typical performance better than 0.0040% 0.1 watt to 150 watts: | ||
|---|---|---|
| 0.0032% | 1W | 400 Hz |
| 0.0024% | 100W | 400 kHz |
| 0.0034% | 150W | 400 Hz |
| Noise | -88 dBv | 22-22k BW Audio Precision P1+DD test set |
| S/N | A-wtd | 120 dB |
- NO bias adjustment, preset during testing.
- NO paste needed, we supply silpads.
- NOT 40 years old or counterfeit. Sanken made the TA-200WA for the Kenwood KR-9600.
- YES, assembled and tested with an original KA-9600 circuit board.
- YES, gold-plated PCB. PCB Finish, ENIG (Gold), compliant with IPC-4552.
- YES, free USPS shipping in the USA.
Hand tools and simple solder skills required. Technical knowledge required. No returns and limited support, this is not for beginners. We do supply instructions and helpful test tips.